Single 18650 Clickfet Squonker Stabilized English figured Walnut with a deep pearl red resin.
Hand built single 18650 Clickfet Squonker
Made from a stunning solid block of stabilized English Figured Walnut with a vein of deep pearl red resin running through.
- Clickfet board by ModMaker
- ModMaker MM510 22mm with brass washer flush fit polished finish (mod will accept upto 24mm Atomizers)
- polished finish brass battery tube.
- designed to accept the ModMaker Dinky bottles
- Polished brass clicky switch
This mod is freshly finished and ready for immediate dispatch.
The clickfet board has the following features-
- Dimensions: 11mm x 10.5mm
- Mosfet:- 30v 100A LFPAK, RDSon 1.35m Ω (typ), VGS(th) 1.46v (typ)
- Operational voltage: 3.1 ± 0.1V - 4.20v
- Low voltage protection: 3.1 ± 0.1V
- Reverse polarity protection: Yes
- Idle current: <10uA
- Timeout Protection: If the battery is around the wrong way the mod will fire.
- Amp Limit: 46.67A (4.2v @ 0.09Ω)
Functions and LED Information
- Low Resistance Protection: When resistance is 0.08 ± 0.01Ω LED's flash 3 times and will not power the mosfet. This is also Short Protection.
- On/Off Function: When off, 5 clicks turns on and LEDs flash 5 times. When on, 5 clicks turns off and LED's flash 5 times.
- Low Voltage: When battery is lower than 3.1 ± 0.1V LEDs flash 10 times and will not power the mosfet.
- Time Out Protection: If the mod is fired for 10 ± 1s the LEDs will flash 8 times and will stop powering the mosfet.
- Reverse Polarity Protection: Yes. The board will not operate.
- In Use: When powering the mosfet the LEDs will be on.